Pvc Coating On Sheet Metal

Pvc coated aluminum trim coil available in a broad array of textures and colors aluminum casings provide a low maintenance and durable trim solution.

Pvc coating on sheet metal.

4 4 has a 4 mil coating of polyvinyl chloride on both sides. Pvc coating or a thin bonded piece of pvc can be applied to any sheet or coil product to help protect the surface from scratches or other damage during shipment incoming inspection and possibly manufacture of part. A pvc un reinforced membrane laminated to galvanized sheet metal cuts and forms like standard sheet metal. Field and flashing membranes heat weld directly to the coated metal.

Sheet metal coils. Pvc plastisol coated sheets are recommended for roofing due to there durability. 4 1 reverse a more economical system has the 4 mil coating on the inside and a grey wash coat on the outside for jobs where extra protection is not needed for the outside of the duct system. Pvc ductwork has also passed thousands of accelerated salt spray and humidity cabinet tests with no loss of adhesion or corrosion resistance.

The coating lightly adheres to the surface of the sheet or coil and is easily removed without any deleterious impact on the sheet or coil product. It can be cut and formed with regular sheet metal equipment and tools with no harm to the coating. When tested class 0 in accordance with building regulations bs476 part 6 1989 and part 7 1987. Plastisol sheeting is a very high quality galvanised steel sheet with a primer paint and the pvc rolled onto it giving a very durable sheet that doesn t fade or scratch easily and with an expected lifespan of 30 years.

Use for metal gravel stops and drip edges metal base and curb flashings and sealant pans and scupper sleeves. Jm pvc membrane laminated with galvanized steel to be fabricated into metal flashings and edge details. Plastic and wood surfaces often require film coatings to protect the surface as well. Polyvinyl coated sheets coils astm a653 hot dipped galvanized substrate pvs polyvinyl coated material is often refered in the hvac industry as pcd coated hot dipped steel combines the strength and durability of steel with the chemical inertness of plastic.

It gives maximum interior and exterior protection. Fabricated by the contractor into metal flashings and edge details. Even the largest diameter ducts are easily cut with portable metal cutting saber saws or circular saws. Pvc membrane may be welded directly to the coated metal edging eliminating the need to strip in the metal with a separate piece of membrane.

Available in hundreds of colors aluminum casing trim is economical and provides a durable low maintenance finish. Pvc coated metal is cut into the appropriate width and used to fabricate metal drip edges or other roof perimeter edging profiles. It is used to provide monolithic water tight protection for both adhered and mechanically fastened roofing assemblies.